Knowledge base ยท Basic jobs

How do I change a wiper blade?

By the Spanner and Jack teamChecked

Check the correct blade size in your owner's handbook, lift the wiper arm away from the screen, press the release clip and slide the old blade off the arm's hook, then slide the new blade on until it clicks and lower the arm gently. It takes a few minutes per blade on most cars, but fixings vary, so follow the handbook and the instructions in the blade's packaging.

Step by step

  1. Get the right blades. Halfords says your owner's manual should list the wipers you need; retailers' registration look-up tools can help too. Front blades are often different lengths, and the rear can differ again (Halfords, how to fit wiper blades).
  2. Park safely, ignition off. Kwik Fit says to make sure automatic wipers are disabled so they can't start while you're working (Kwik Fit, how to replace windscreen wipers).
  3. Protect the screen. Halfords suggests a rolled-up towel on the glass under the blade, because a bare arm that snaps back can crack the windscreen. On some cars the wipers have to be moved to a service position first (see your handbook).
  4. Lift the arm until it stays upright.
  5. Remove the old blade. On the common hook-type arm, press or release the clip and slide the blade down to unhook it. Other fittings use a different clip.
  6. Fit the new blade the same way, using any adapter supplied in the box, until it clicks into place. Don't force plastic clips.
  7. Lower the arm gently, check the blade sits flat, then test it with screenwash.

Halfords recommends replacing blades in pairs, since they wear at the same rate. Kwik Fit suggests replacing them about every 12 months, or sooner if they smear, skip or squeak. Halfords also offers in-store fitting if you'd rather not do it yourself.

Why it matters for the MOT

Wipers are part of the MOT. The DVSA's inspection manual lists a missing or non-working wiper, a defective blade, or a blade obviously not clearing the windscreen as defects, and washers must provide enough fluid for the wipers to clear the screen (MOT inspection manual, section 3).

Sources

On this site